MacDive Forums

As above, you will need to follow the test instructions and send your data.

There is obviously a different problem, as the issue being discussed here is resolved. Without your data to investigate, there's not much I can do.

Hi.

I did two dives today:
one without gas switch, one with gas switch.
But as I tell in my post: even with the beta version of MacDive I still get absurd data for the dive with gas switch.
Can you get me a work-around?

Bruno

nick wrote:As above, you will need to follow the test instructions and send your data.

There is obviously a different problem, as the issue being discussed here is resolved. Without your data to investigate, there's not much I can do.

Sorry, I didn't see your answer previously.
I am willing to help you with data, but can you tell me more?
What data?
You refer to a test program, but to test what? connectivity? That will not be the problem, for I can download all dives to my Macbook if these dives are NOT with a gas switch...

Bruno

It is described earlier in this thread.

Follow the instructions here:

viewtopic.php?f=5&t=407

Using the "ostc" test.

Thanks.

OK.

I sent the OSTC.DMP and OSTC.LOG files to your email address.

Problem resolved and new beta is up. I believe this fixed your issue.

I have just installed the beta and can confirm that this has resolved the issues that I had with the OSTC 2C download which was showing up as the same as the issue seen on the OSTC 2N.

Thanks very much,

Callum