Page 1 of 1
Select the Cerification data
Posted: Tue Apr 30, 2013 12:55 am
by jwwphoto
I am looking the Table view of all dives and the last four from this weekend have "No Value" noted. When I double click there, it only offers me "No Value".
If I look at the Form view and click on the General tab, I see there the button for Certification. Why aren't my there certification levels available there? The button is already labeled "No certification selected".... Where do I select it at?
Jeff W Waldrop
Re: Select the Cerification data
Posted: Tue Apr 30, 2013 4:03 am
by nick
I assume you created some Certifications?
Re: Select the Cerification data
Posted: Tue Apr 30, 2013 5:08 am
by jwwphoto
Yes, three in fact. OW, AOW and Nitrox. I imported three dives from the weekend and can seem to select Adv Open Water.
Re: Select the Cerification data
Posted: Tue Apr 30, 2013 5:09 am
by nick
Did you set the Diver on the Certification to the same one that is assigned to the Dive ?
As of a couple of updates ago, Certifications are filtered by the Diver (this is for people with multiple divers etc).
Re: Select the Cerification data
Posted: Tue Apr 30, 2013 5:12 am
by jwwphoto
Well, I am the only diver, but was not aware I have to tell it I was the diver. I'll take a look. Thanks, Nick.
Jeff
Re: Select the Cerification data
Posted: Tue Apr 30, 2013 5:12 am
by jwwphoto
Well, I am the only diver, but was not aware I have to tell it I was the diver. I'll take a look. Thanks, Nick.
Jeff
Re: Select the Cerification data
Posted: Tue Apr 30, 2013 5:28 am
by jwwphoto
Thanks, I figured it out....... Appreciate the help. Keep up the good work.
Jeff
Re: Select the Cerification data
Posted: Tue Apr 30, 2013 5:35 am
by nick
No problem.
Maybe it would help to default Certifications to be owned by the only diver, if you've only got one diver. It's probably a little obscure as is.