MacDive Forums

Hi,

I would like the working pressure of the cylinder changed to bar instead of psi when setting up a new cylinder. Everything else is in bar but the working pressure is still in psi (usually 3000 psi) but for simplicity it would be nice if it also was in bar.

Working pressure is irrelevant in metric, so the field isn't actually used. It only matters in PSI for SAC calculations.

nick wrote:Working pressure is irrelevant in metric, so the field isn't actually used. It only matters in PSI for SAC calculations.

ok thanks for the clarification.

I have been meaning to just hide the working pressure field!