Page 1 of 1
XML Import problem with "bar" pressure
Posted: Fri Jan 30, 2015 8:28 pm
by bubffm
Hi,
I exported my MacDives into MacDive XML and reimported them. Noticed that the bar pressures get recalculated by a factor 14.5.
205 bar pressure after re-import is shown as 14.14 bar (!!) Could this be some metric / imperial conversion bug?
Thanks
bubffm
Re: XML Import problem with "bar" pressure
Posted: Sat Jan 31, 2015 2:47 am
by nick
Could you send me the XML file?
It sounds like a conversion issue, but I'll need to investigate. I've not run in to this.
Re: XML Import problem with "bar" pressure
Posted: Sat Jan 31, 2015 2:55 am
by nick
Never mind, I see the problem. Wow, weird, I'm surprised that hasn't been noticed previously.
This is fixed for the next release. If you need an updated version now, please email support and I will send you a beta.
Re: XML Import problem with "bar" pressure
Posted: Sat Jan 31, 2015 5:47 am
by bubffm
nick wrote:Never mind, I see the problem. Wow, weird, I'm surprised that hasn't been noticed previously.
This is fixed for the next release. If you need an updated version now, please email support and I will send you a beta.
Good you found it. I'm fine for now, corrected it manually. Will wait for the next release
