Partially corrupted Dive from Computer
Posted: Mon Sep 03, 2018 10:15 am
Hey,
New to this board, and also new to Macdive, but loving it so far.
I have imported a stack of dives from my dive computer (Suunto D6i), and that all went well, however a dive I did early this morning didn't quite import properly.
Basically, it was a dive where I was diving with 2 tanks (12.2L standard tank with transmitter, and 7L stage/pony tank without transmitter). I used my main tank till I got down to 50bar, then switched to the 7L tank till it was almost empty, and then swapped back right at the end to my main tank for the last couple of minutes.
When I import my dive into the Suunto DM5 software, it shows the 2 tanks correctly, and no missing data. When I import the dive into Macdive directly from my dive computer, it sees that there are 2 tanks being used, but for the whole of the 2nd tank time, the data is crazy (going to max depth of around 430m, and temps ranging from 118oC to -93oC etc).
If I export the dive from DM5 to SDE format, and import into MacDive, it imports correctly but only as 1 tank (but no crazy data from what I could see).
Any idea what is happening when I import directly from my dive computer? Every other import has gone fine (although this is the first time I used 2 tanks).
Images from both MacDive and DM5 for comparison:
MacDive - http://higgalls.com/dive/dive-macdive.jpg
MD5 - http://higgalls.com/dive/dive-dm5.jpg
Thanks.
New to this board, and also new to Macdive, but loving it so far.
I have imported a stack of dives from my dive computer (Suunto D6i), and that all went well, however a dive I did early this morning didn't quite import properly.
Basically, it was a dive where I was diving with 2 tanks (12.2L standard tank with transmitter, and 7L stage/pony tank without transmitter). I used my main tank till I got down to 50bar, then switched to the 7L tank till it was almost empty, and then swapped back right at the end to my main tank for the last couple of minutes.
When I import my dive into the Suunto DM5 software, it shows the 2 tanks correctly, and no missing data. When I import the dive into Macdive directly from my dive computer, it sees that there are 2 tanks being used, but for the whole of the 2nd tank time, the data is crazy (going to max depth of around 430m, and temps ranging from 118oC to -93oC etc).
If I export the dive from DM5 to SDE format, and import into MacDive, it imports correctly but only as 1 tank (but no crazy data from what I could see).
Any idea what is happening when I import directly from my dive computer? Every other import has gone fine (although this is the first time I used 2 tanks).
Images from both MacDive and DM5 for comparison:
MacDive - http://higgalls.com/dive/dive-macdive.jpg
MD5 - http://higgalls.com/dive/dive-dm5.jpg
Thanks.