Manually editing raw data
Posted: Sun May 29, 2011 11:50 pm
Nick,
Many thanks for showing the Raw data, because it identified a problem with my GEKKO.. it's been "self diving" on me. Fortunately I'm 1y11m into my 2y warranty to I get a repair/replace (and the GEKKO is OOP so I'll likely get the ZOOP out of the deal!)
At the end of a few of my recent dives, I get a surface "alert" at xxxx samples, but it then continues to show depth of .33 for yyyy samples after it. IE one of my dives ended at 38:50 after entering the water, but the computer carried on logging depth of .33 until 83:50.. the delta suspiciously is the SIT time until I next went to depth > .33.
As this "buggers up" the profile on the printout ("compresses" the curve due to the .33 outliers for 0h45m), I was wondering if I can delete the 'errant' data? If not, no biggie, but I thought I'd ask.
Asking here as I'm sure that the need may come up again for others.
Thx,
B.
Many thanks for showing the Raw data, because it identified a problem with my GEKKO.. it's been "self diving" on me. Fortunately I'm 1y11m into my 2y warranty to I get a repair/replace (and the GEKKO is OOP so I'll likely get the ZOOP out of the deal!)
At the end of a few of my recent dives, I get a surface "alert" at xxxx samples, but it then continues to show depth of .33 for yyyy samples after it. IE one of my dives ended at 38:50 after entering the water, but the computer carried on logging depth of .33 until 83:50.. the delta suspiciously is the SIT time until I next went to depth > .33.
As this "buggers up" the profile on the printout ("compresses" the curve due to the .33 outliers for 0h45m), I was wondering if I can delete the 'errant' data? If not, no biggie, but I thought I'd ask.
Asking here as I'm sure that the need may come up again for others.
Thx,
B.