Page 1 of 1
Cannot read memory
Posted: Mon Feb 15, 2010 12:52 am
by matthi_k
I am using Macdive 1.5.2 with OS X10.6.2 and a Suunto Cobra with a Smartinterface USB cable, and even after following all instructions step by step I get "Cannot read memory" from Macdive after starting "Import" on the File Menu. Is there any kind of diagnosis I can run? Any advice on how to proceed, perhaps?
Thanks a lot!
Matthias
Re: Cannot read memory
Posted: Mon Feb 15, 2010 2:26 am
by TnT
Can you run the
vyper test application to find out whether the error is in the libdivecomputer library or macdive itself? Instructions are available on the
libdivecomputer website.
Re: Cannot read memory
Posted: Mon Feb 15, 2010 11:06 am
by nick
Did you install the smart interface USB driver ? (NB: I am not sure if this is snow leopard compatible, it doesn't seem to mention anything on the website).
If you go preferences -> advanced -> scan for serial port, what shows up (when the cobra is in pc transfer mode) ?